How to Clean Gun Parts

[Asfand]

As any rifle owner knows, proper care means regular cleaning of the basic rifle parts. For the novice, this may seem like an daunting task, but by following the proper steps, the rifle can be cleaned safely and effectively. The guide below walks rifle owners through the basics of cleaning rifle parts, but it is always far better follow any special instructions offered by the gun's manufacturer.

Un-load the rifle. Before doing anything else, make sure that the rifle is utterly unloaded. Check the chamber and the bat berrel to make sure that it is free and clear of bullets. Never skip this most important first step.

Proceed to a well-ventilated work area with a large, flat work surface to work on. The rifle chemicals which will be used for cleaning have a strong smell, so proper setting up is a must. The table or workbench should be covered by a soft cloth where the rifle can be taken apart without worry of scratch or damage.

Take out the rifle cleaning kit designed for the type of rifle being cleaned along with a method of getting clean cloths. There are different cleaning kits for different types of guns. If you own more than one type of gun, there are also cleaning kits that are made to try a variety of rifle types. They are called General Cleaning kits and can usually be purchased at any rifle or hunting supply store. The basic waste the cleaning kit add the following: a rifle chemical cleaning solvent, oil for lubrication, a cleaning fly fishing line with videos and cleaning patches. Some kits also include a small brush, but a toothbrush will work as well.

Now it is time to begin the cleaning process. Dip the brush or toothbrush in the chemical cleaning solvent and clean the inside of the storage container and rifle frame. Stabilizing Brace Although these areas may be dirty, with proper and consistent cleaning, they do not have an excessive build up of dirt and debris. After scrubbing, wash the areas with a clean, dry publication to remove the dirt and chemical cleaner.

Attach a cleaning spot to the end of the cleaning fly fishing line using a clip provided. Soak the cleaning spot with rifle chemical cleaning solvent until it is saturated, but not leaking. Slowly push the fly fishing line into the bat berrel, cleaning the inside of the rifle as it is pushed through. Replace the dirty, wet cleaning spot with a clean one and soak it with solvent when the fly fishing line pokes through the other end of the bat berrel. Continue cleaning the bat berrel this way, replacing the cleaning spot each time it comes through the bat berrel. It might take 4 to 5 times before the bat berrel is utterly clean and a dry spot 35mm slides through with no remains left on it.

The final step is to lubricate the rifle parts with the oil that came in the cleaning kit. Attach a fresh cleaning spot to the end of the cleaning fly fishing line, soak it in oil and slide it into the gun's bat berrel and back out again. Then, using a clean publication, apply a small amount of oil to the moving parts of the rifle, testing them along the way to make sure that they are in good working order.

Once the rifle is cleaned, put away the rifle chemicals and work cloth. Take the time to store things neatly, so your the very next time the rifle is just about to be cleaned they can be easily found. Rifle care is about being meticulous, patient and staying with a routine. With the proper care and cleaning, a rifle can last a lifetime.